Newsletter
Launch X431 PAD V Perform EPS Start-up for 2024 BMW X1 U12 Chassis
It’s necessary to perform the start-up of the EPS system for 2024 BMW X1 after replacing the EPS (Electric Power Steering). Launch X431 PAD V Elite diagnostic scanner fully supports this specialized function, ensuring a seamless activation process.
Operation guide:
1.Turn on the vehicle ignition switch, connect the diagnostic connector, and choose BMW V51.50 or later version
2.Select [Automatically Search] and confirm the vehicle identification info.
It's a 2024 BMW U12 Chassis X1 sDrive25Li.
Click [NEXT]
3.Select Special Function-> Chassis-> EPS: Steering Start-Up
4.Read the service info introduction carefully, click [Continue] to begin the Start-up of the EPS
5.Click [F2] to carry out Start-Up again.
6.The steering assistance is activated for the duration of the start-up, click [Continue].
7.The EPS was reset to the default condition, continue standard start-up, click [Continue].
8.The brake must not be actuated during the Start-up, start position of the steering wheel (approximately 30 degdegrees to the right), click [Continue] to start the standard start-up.
9.The standard start-up has now been enabled, the steering assistance is active.
10.Turn the steering wheel according to the previous step prompt. It automatically jumps to the next step when the conditions are met.
11.The determination of the necessary system parameters for the EPS function is completed, click [Continue].
12.The EPS was successfully put into the operation,start to delete EPS fault memory.
13.Delete EPS fault memory successfully, click [Continue] to complete the standard Start-up
14.The system network consisting of the following control units has been successfully synchronised and put into operation. No further repair measures required on the steering system, click [Continue]
This function is completed by X431 PAD V.
Tech support:
Email: sales@launchx431.fr
WhatsApp: +86 18750906257
www.launchx431.fr
Operation guide:
1.Turn on the vehicle ignition switch, connect the diagnostic connector, and choose BMW V51.50 or later version
2.Select [Automatically Search] and confirm the vehicle identification info.
It's a 2024 BMW U12 Chassis X1 sDrive25Li.
Click [NEXT]
3.Select Special Function-> Chassis-> EPS: Steering Start-Up
4.Read the service info introduction carefully, click [Continue] to begin the Start-up of the EPS
5.Click [F2] to carry out Start-Up again.
6.The steering assistance is activated for the duration of the start-up, click [Continue].
7.The EPS was reset to the default condition, continue standard start-up, click [Continue].
8.The brake must not be actuated during the Start-up, start position of the steering wheel (approximately 30 degdegrees to the right), click [Continue] to start the standard start-up.
9.The standard start-up has now been enabled, the steering assistance is active.
10.Turn the steering wheel according to the previous step prompt. It automatically jumps to the next step when the conditions are met.
11.The determination of the necessary system parameters for the EPS function is completed, click [Continue].
12.The EPS was successfully put into the operation,start to delete EPS fault memory.
13.Delete EPS fault memory successfully, click [Continue] to complete the standard Start-up
14.The system network consisting of the following control units has been successfully synchronised and put into operation. No further repair measures required on the steering system, click [Continue]
This function is completed by X431 PAD V.
Tech support:
Email: sales@launchx431.fr
WhatsApp: +86 18750906257
www.launchx431.fr