Newsletter
How to Replace BMW MSD81.2 ECU by Launch X431 IMMO Plus/IMMO Elite?
With the Launch X431 IMMO Plus/IMMO Elite, you can successfully replace a BMW MSD81.2 ECU with a used one by reading the ISN from the original ECU, modifying the donor ECU’s flash, and writing the correct ISN. This process also applies to MSD80, MSD85, MSV80, and other models.
Step-by-Step ECU Replacement Guide
1. Select the ECU Replacement Function
-
Navigate to: BMW Function > Main Function > Engine Module Replacement > Bench Mode > MSD81_TC1796.
-
Refer to the wiring diagram for proper connections.
2. Connect the Original ECU
-
Establish a connection with the ECU (security login may take some time).
-
Read and verify the Chip ID.
3. Backup the Original ECU Flash Data
-
Select Backup Flash Data from the original ECU.
-
Securely save the flash data.
4. Extract the ISN Code from the Original ECU
-
Choose Flash Data Decryption to retrieve the 32-digit ISN code from the original ECU.
-
Record the ISN code for later use.
-
Disconnect the original ECU.
5. Connect the Replacement ECU
-
Connect the donor ECU to the X431 X-Prog3 following the same wiring diagram.
-
Establish a connection (perform security login).
6. Back Up the Replacement ECU Flash Data
-
Back up the donor ECU’s flash data and save it securely.
-
Extract the ISN code from the donor ECU’s flash data.
7. Modify the Replacement ECU ISN
-
Navigate to the Change ISN function.
-
Input the 32-digit ISN code from the original ECU.
-
Successfully modify and save the updated flash data.
8. Verify the Updated ISN Code
-
Extract the ISN code from the modified flash data and confirm it matches the original ECU.
9. Write the Updated Flash Data to the Replacement ECU
-
Select Restore Flash Data.
-
Write the modified flash data back to the replacement ECU.
10. Install and Test
-
Disconnect the ECU and install it in the vehicle.
-
Test the replacement ECU to ensure it functions correctly with the car.